3924 - 3A St NE, Calgary, AB, T2E 6R4 Call us: 403-277-0152 general@universalcycle.ca / drayko@universalcycle.ca
• Flat rate shipping of $10 on orders over $99* • FREE SHIPPING on orders over $199*
*This offer applies to items under 10lbs / cubed weight. No PO BOX or RR Addresses.
• 10% OFF In Store Pick Up - Use coupon code: THANKYOUCALGARY
Yamaha
Manual Petcock KLR650
$60.00
Manual Petcock
Fits: 1987 - 2018 Kawasaki KLR650
Part number: mpcy
Description:
Manual Petcock, replaces factory vacuum petcock. Direct bolt on. Eliminate one more potential issue with the factory Kawasaki setup. This setup allows more fuel before reserve due to tube height, but less fuel available after reserve is reached. Total fuel is the same, of course. This petcock is on the left in the picture. Original Kawasaki part on the right for comparison. You can install the original (taller) pipe in your new petcock. Use pliers to carefully remove each, and gently push the old pipe into the new petcock. They stick pretty well just pushed in. You could put a small amount of fuel proof epoxy on it. I don't have a source for the filters on top of the pipes, so be careful.
If you install this petcock with the SW Motech engine/body crash guards, you will need to notch the lower outside edge of the selector lever. Nothing difficult, still easy to use. Still have the long life and reliability of the manual petcock.
* Item may differ slightly from image.
Fits: 1987 - 2018 Kawasaki KLR650
Part number: mpcy
Description:
Manual Petcock, replaces factory vacuum petcock. Direct bolt on. Eliminate one more potential issue with the factory Kawasaki setup. This setup allows more fuel before reserve due to tube height, but less fuel available after reserve is reached. Total fuel is the same, of course. This petcock is on the left in the picture. Original Kawasaki part on the right for comparison. You can install the original (taller) pipe in your new petcock. Use pliers to carefully remove each, and gently push the old pipe into the new petcock. They stick pretty well just pushed in. You could put a small amount of fuel proof epoxy on it. I don't have a source for the filters on top of the pipes, so be careful.
If you install this petcock with the SW Motech engine/body crash guards, you will need to notch the lower outside edge of the selector lever. Nothing difficult, still easy to use. Still have the long life and reliability of the manual petcock.
* Item may differ slightly from image.
Customer Reviews
This product has not yet been reviewed.
Share:
Share on Facebook Share on Twitter Share on Pinterest Tell a friend