3924 - 3A St NE, Calgary, AB, T2E 6R4 Call us: 403-277-0152 general@universalcycle.ca / drayko@universalcycle.ca
• Flat rate shipping of $10 on orders over $99* • FREE SHIPPING on orders over $199*
*This offer applies to items under 10lbs / cubed weight. No PO BOX or RR Addresses.
• 10% OFF In Store Pick Up - Use coupon code: THANKYOUCALGARY
SW-Motech
H/Bar Risers 7/8in SW-MOTECH
$119.00
Handlebar risers
Provides a more upright, comfortable riding position by raising the original 7/8" (22mm) diameter tubular handlebar. No need to replace your handlebars - simply remove the original top clamp, place the riser between the handlebar and original bottom clamp, and reinstall top clamp using included hardware. Choose a rise height of 20mm (0.8"), 25mm (1"), 30mm (1.2"), or 50mm (2").
This item has replaced LEH.00.039.102 and LEH.00.039.103 and covers both of their application ranges.
For use with original top clamp or included matching SW-MOTECH top clamp.
No change of control cables, wiring, or hoses is required for most motorcycle models for 20mm, 25mm, or 30mm handlebar risers, HOWEVER:
The installer should always check for adequate cable/wiring/hose slack after installing any handlebar riser!
Simply put, the amount of cable slack varies on factory bikes even within a single model and year, so while 99.9% of all bikes will not need adjustment of cables to install handlebar risers, you should ALWAYS check for adequate slack after installation.
Provides a more upright, comfortable riding position by raising the original 7/8" (22mm) diameter tubular handlebar. No need to replace your handlebars - simply remove the original top clamp, place the riser between the handlebar and original bottom clamp, and reinstall top clamp using included hardware. Choose a rise height of 20mm (0.8"), 25mm (1"), 30mm (1.2"), or 50mm (2").
This item has replaced LEH.00.039.102 and LEH.00.039.103 and covers both of their application ranges.
For use with original top clamp or included matching SW-MOTECH top clamp.
No change of control cables, wiring, or hoses is required for most motorcycle models for 20mm, 25mm, or 30mm handlebar risers, HOWEVER:
The installer should always check for adequate cable/wiring/hose slack after installing any handlebar riser!
Simply put, the amount of cable slack varies on factory bikes even within a single model and year, so while 99.9% of all bikes will not need adjustment of cables to install handlebar risers, you should ALWAYS check for adequate slack after installation.
Customer Reviews
This product has not yet been reviewed.
Share:
Share on Facebook Share on Twitter Share on Pinterest Tell a friend